- 36 -
There is an "OPEN" mark on the bottom of the remote control, please
slowly pry open the surrounding gap along the groove position of this
mark to open.
1.
After opening, gently pry the battery out of the notch in front of the
battery compartment, then remove the old battery, then put the new
battery in and put the back cover of the remote control in place.
2.
Replacing the remote control battery:
Note: When the power is low, the battery needs to be replaced(The
battery model of the remote control is a CR2032 battery). It does not
support charging.
ENEN
To Next Page
Loading...
