Vantrue Element 3 - Wiring and Rear Camera Setup

- 9 -
EN EN EN EN
Take out the rear camera cable, connect the main camera and the
rear camera, and take out the car charger to connect it. After the
camera is powered on, choose a suitable location and install it.
5.
Rear Camera Installation: Please select the installation position on the
rear windshield. We recommend that you select a position close to the
center of the rear windshield, and avoid the defogging line on the rear
windshield, so as not to affect the video effect. Remove the protection
film of the sticky pad and rear camera lens. Fix the rear camera in the
selected position and adjust the angle, then use the rear camera cable
to connect the rear camera with the main front camera.
6.
(Correct wiring method) (Wrong wiring method)