- 18 -
ENEN
A.Record Setup
-Resolution: The E3 camera has 4 resolution modes: Front+ Cabin+ Rear/
Front+ Cabin/ Front+ Rear/Single Front;
Front+ Cabin+ Rear Recording: 1944P+1080P+1080P 30FPS;
1440P+1080P+1080P 30FPS; 1080P+1080P+1080P 30FPS; 1440P+1080P+720P
30FPS; 1440P+720P+720P 30FPS; 1080P+1080P+720P 30FPS;
1080P+720P+720P 30FPS; 720P+720P+720P 30FPS;
Front+ Cabin Recording: 1944P+1080P 30FPS; 1440P+1080P 30FPS;
1080P+1080P 30FPS; 1080P+720P 30FPS; 720P+1080P 30FPS; 720P+720P
30FPS;
Front + Rear recording: 1944P+1080P 30FPS; 1440P+1080P 30FPS;
1080P+1080P 30FPS; 1080P+720P 30FPS; 720P+1080P 30FPS; 720P+720P
30FPS;
Front recording: 2592x1944P 30FPS; 2560x1440P 30FPS; 1920x1080P 30FPS;
1280x720P 30FPS.
-Loop Recording: Default setting is 3 min. You can choose the options
among 1/3/5 min and OFF.
-IR LEDs: Default setting is Auto. You can select auto, on, or off.
-G-Sensor: Select the level of G-sensor you need, then you can set 3
directions (Front + Rear/Left + Right/Up + Down). The G-sensor value in
each direction can be selected as 1/2/3/4/5/Off. The higher the sensitivity
level, the easier it is to trigger event recording. G-sensor is most sensitive
when set to 5.
System Setup
OK
To Next Page
Loading...
Need help?
General
