- 4 -
1.4 Installing the Power Cord
Connect the power cord to the fuse box as follows.
Step 1: the red power cable is connected to the
positive terminal of the battery.
Step 2: the ACC signal wire (yellow wire) is
connected to the ACC power fuse of the battery.
Step 3: The black ground wire is connected to the
negative terminal of the battery or the override
position.
Step 4: start the motorcycle power supply and wait
for the device to start.
Step 5: After confirming that the power supply is
properly installed, use the cable ties to organize the
storage lines and secure them to the motorcycle.
Note:
<1>. Before installation and wiring, you need to turn
off the motorcycle and turn off the motorcycle
power to avoid short circuit during the operation.
<2>. For driving safety, please avoid leaving too
long power cables exposed. If necessary, please
use insulating tape to wrap and fix them.
Select the location
in the fuse box
where the fuse can
be accessed.
To Next Page
Loading...
Need help?
General
