Vantrue S1 User Manual

- 16 -
4.7 Parking Mode
Parking Mode operates as a sentry
function under different situations. To
activate Parking Mode, go to “Record
Setup”►“Parking Monitor”, press OK and
select ON.
When the Parking Mode has been
turned on, and no movement is
detected in front of the camera after 5
minutes of recording, then Parking Mode
is activated. This is represented by an
icon (P) at the right side of the screen.
In Parking Mode, once the camera
detectsmovement at the front, it will start
auto- recording; it will stop recording
after 10 seconds of inactivity.
To manually activate Parking Mode,
press and hold the OK button until the P
icon appears on the screen.
The camera will exit Parking Mode if it
detects it has been moved.
NOTE: To ensure the camera is able to
function in Parking Mode, please keep it
powered with a mobile power bank or
hardwire it directly to the car battery. We
do not recommend running the camera
continuously for too long time.
00:00:16
000MPH
16:08:082019/04/10
EV
0.0
1920x1080P 30FPS
HDR
3
OnDash S1
00:00:08
000MPH
16:08:082019/04/10
EV
0.0
1920x1080P 30FPS
HDR
3
OnDash S1

Vantrue S1 Specifications

General

Front Frame Rate	30fps
Rear Frame Rate	30fps
Front Viewing Angle	170°
Rear Viewing Angle	160°
Video Format	MP4
Image Format	JPG
GPS	Built-in
G-Sensor	Yes
Parking Mode	Yes
Loop Recording	Yes
WDR	Yes
Wi-Fi	No
Front Camera Resolution	1080P
Rear Camera Resolution	1920x1080P
Storage	Micro SD card up to 256GB
Operating Temperature	-20°C to 70°C (-4°F to 158°F)
Sensor	Sony STARVIS