Vapac VapaNet - User Manual

These instructions contain operating information and should be left with the unit.
Electro Boiler
Units
Alpha-Numeric Display Module
Operation Manual
Edition 3.1
(For use with Software version 7.4 & subsequent issues)
Installation in countries covered by EC Directives:
This product will meet the requirements of the Low Voltage Safety Directive 73 / 23 EEC and the
EMC Directive 89 / 336 EEC when installed in accordance with the instructions contained in this
manual. Failure to comply with these instructions may invalidate the manufacturer's warranty or
any certificate/declaration of conformance requested to be supplied with the unit.

Summary

Introduction and Display Interface

Alpha-Numeric Display Overview

Details the alphanumeric keypad and display for unit operation.

Non Password Protected Menu Options

Unit Setup and Configuration Options

Covers language selection, unit attachment, factory setup, and network setup.

Display Management and Reset Functions

Options to reset the display and re-synchronize data.

Master Vapac System Parameters

Displays unit, cylinder, and slave unit status and parameters.

System Performance and Diagnostics

Information on master/slave operation, cylinder performance, and system status.

Advanced Unit and Cylinder Settings

Configuration of unit type, voltage, electrodes, and cylinder maintenance.

User Level Password Protected Menu

Accessing User Settings

Guide to accessing user-level menus with password "4602".

User Level Configuration Options

Lists available configuration parameters for user-level access.

Service Engineer Password Protected Menu

Accessing Service Engineer Settings

Instructions for entering service engineer menus with password "5699".

Service Engineer Configuration Options

Lists advanced configuration and diagnostic options for service engineers.

Operational Adjustments and Tuning

Master Vapac Parameter Tuning

Adjusts master Vapac set point, proportional band, and RH offset.

Unit and Cylinder Performance Tuning

Allows adjustments for constant output, quick start, and run/fault outputs.

Service and Maintenance Procedures

Manual Control of Unit Functions

Manual operation of feed valve, drain pump, and manual drain.

Fault Alarms and Status Reporting

Configures fault alarm types and status display for alarms.

Vapac VapaNet Specifications

General

Brand	Vapac
Model	VapaNet
Category	Boiler Supplies
Language	English