1. Remove the mouthpiece
using finger grooves
2. Grind well and tamp down
(like an espresso) using the back end of the Stir Tool
3. Replace mouthpiece back on the device
8
• Heating chamber heats up in as little as 30
seconds (the lower the temp, the faster the heating)
• For best results fill the entire chamber with finely
ground leaf and tamp down. This allows for even
heat distribution and room to stir the material if
necessary throughout usage
• To maximize efficiency, allow the unit to cool and
then stir flower before the next cycle. Your LITE is
equipped with a 30-minute auto-shutoff timer.
After each session it goes into stand-by mode to
prevent battery waste
• The LITE will automatically return to the last
temperature setting used
• For best results, clean your device at least
once a week.
HOW TO LOAD FLOWER
USER TIPS
To Next Page
Loading...
