EasyManua.ls Logo

Vari Lite VL3000 Wash - User Manual

Vari Lite VL3000 Wash
245 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

Table of Contents

Questions and Answers

  • D
    David BrownAug 11, 2025
    What to do if Vari Lite VL3000 Wash Lantern displays 'Pan/Encoder/Fail'?
    • B
      Bradley BishopAug 11, 2025
      If your Vari Lite Lantern shows a 'Pan/Encoder/Fail' error, try these steps: First, check the MCB pan/tilt connector (J8) to ensure it's properly connected. Next, verify that the pan motor is connected to its power source. If the issue persists, the encoder might be faulty, consider replacing the pan end-of-travel/encoder sensor assembly.
  • L
    lewisjacquelineAug 19, 2025
    What to do if Vari Lite VL3000 Wash displays 'Tilt/Encoder/Fail'?
    • L
      Lynn GentryAug 19, 2025
      If your Vari Lite Lantern shows a 'Tilt/Encoder/Fail' error, check the MCB pan/tilt connector (J8) to ensure it's properly connected. Next, verify that the tilt motor is connected to its power source. If the issue persists, the encoder might be faulty, consider replacing the tilt end-of-travel/encoder sensor assembly.
  • R
    Robert SmithAug 27, 2025
    What to do if Vari Lite Lantern displays 'Pan No Sens'?
    • A
      angelabuckAug 27, 2025
      If your Vari Lite Lantern displays a 'Pan No Sens' message, first ensure the flag is properly attached to the large pulley. Also, verify that the flag passes through the sensor at a sufficient depth to engage the sensor beam. Another potential cause is a disconnected, extremely loose, or improperly installed pan belt. If this is the case, properly install the belt between the pan motor and the large pulley.
  • V
    vsullivanSep 2, 2025
    What to do if Vari Lite VL3000 Wash displays 'Tilt No Sens'?
    • E
      erik65Sep 2, 2025
      If your Vari Lite Lantern displays a 'Tilt No Sens' message, first ensure the flag is properly attached to the large pulley. Also, verify that the flag passes through the sensor at a sufficient depth to engage the sensor beam. Another potential cause is a disconnected, extremely loose, or improperly installed tilt belt. If this is the case, properly install the belt between the tilt motor and the large pulley.

Vari Lite VL3000 Wash Specifications

General IconGeneral
TypeWash
Lamp Life750 hours
Pan Range540°
Tilt Range270°
Pan/Tilt SpeedVariable
Control ProtocolsDMX512, RDM
Light SourceDischarge Lamp
Color MixingCMY
ReflectorEllipsoidal
Dimmer0-100%
DMX Channels16

Related product manuals