VASNER
16
• Denitely do not let your device come into contact with water.
• The electrical connection of the device must be separated from the mains
during mounting and maintenance or repair works. Device must be un-
plugged to be separated from the mains.
• Ensure that the feed cable and the plug is clean and dust-free prior to use.
• Never unplug the feed cable from the plug by tugging on the cable. Ensure
that you hold the plug correctly as you plug it into or take it out of the so-
cket. Do not touch the feed cable.
• Do not touch the cable with wet hands.
• Do not make a joint to the feed cable. Otherwise, malfunction, electric
shock or re may occur.
• Do not pass the feed cable under heavy objects. Otherwise electric shock or
re risk may occur.
• Do not turn o your heater only by unplugging it or shutting down the
fuse, always turn o by using the heater tube function button.
• Fire risk exists if the heater is covered by or positioned close to curtains or
other combustible materials.
• The ame protector of this heater is for preventing direct access to the hea-
ter elements and must be in place while the heater is in use.
• Do not use your device outside its intended purpose. (Do not use it for dry-
ing clothes or keeping animals or plants warm.)
• Never try to clean the device with solvents or ammable liquids. (It may
cause electric shock or re!)
• Do not operate the device while sleeping or while away from where the
device is located.
• Refrain from using extending cord, it might cause re due to overheating. If
you have to use an extending cord, the cable cross section must be at least
2 mm² (14 AWG).
GB
To Next Page
Loading...
