Clutch Push Rod
Cltucb
Adjusting Turnbuckle
Cluicb
Arm
Clutch Rod Pivot Link
Clutch Pull Rod
Ge4I
Shift Bearing
GeZI
Shift Arm
Gee:
Shift Rod
H;mdle Adjustment
Bevel Gear Bearing Adjust. Cap
Gear
Case Inspection Cover
ottle Wue
Gear Shift
Handle Adjustment
:rb
:eigh.
adjustment is made by removing the upper handle
-=
re-serting in the hole for the desired height.
- ce acj'::stment for handle row-clearance is made by movement
0;::
adjustment rod, No.9 in illustration.
may require clutch readjustment by
Magneto
=onnt on
Elex-T'reds
the latest type "U" American Bosch
which should not require frequent servicing. The mag-
;:;;.ay
be serviced at the shop of your local. authorized American
agent, or sent direct to us for repair.
=gnetos are of the fixed spark type-timed so that the
open and spark occurs at
0/8"
of piston stroke before compres-
~ead center. This adjustment is made
in
the adjustment disc
as No.1 in the photograph.
~.i=ting the points indicated as No.2 and No.3, reface,
if
and reset to the gap indicated by the gauge on adjustment
"-g:.ero switch No.4 bas arrow indicator to "Off" and "00."
c:-.;;t
spark plug points to the gauge on the magneto adjusting
The three positions of Forward, Reverse and Neutral are indi-
cated F, Rand N, located under and indicated by gear shift arm,
No.7 in illustration.
(COTTER KEY
r
Clutch Adjustment
The multiple-plate oil-bathed clutch requires little adjustment
once set. Adjustment for release with dog engaged, and crutch
handle convenience, is made by clutch adjustment turnbuckle No.2.
Be sure that clutch rod pivot link No.4 works freely, but is
not loose.
The release adjustment is sometimes necessary when the handles
are adjusted for height or row clearance.
If
clutch slips, remove inspection plate No. 11 and tighten clutch
spring nut to increase spring tension. Be sure to replace cotter key
in adjustment nut.
Chain Adjustment
Traction chains should be adjusted so that they have
Ya"
sag on
top when chain is on a level floor, and tight around the wheels-s-
when they become slack. Adjust by loosening rear axle bolts and
____ -JiglUeninlL 12ull scr~ just behind rear axle on the gearcase~ Be~
.-e
haviag cracked or broken porcelain should be replaced. sure to re-tighten axle bolts.
To Next Page
Loading...