Note:
Maintenance
03/04
ION Button
Press the ION Button to activate or turn off the ION mode.
1. Use soft brushes to dust off the f ilter regularly for better purif ication. Don’t wash it with water.
2. Replace the f ilter when the Change Filter Reminder flashes:
1. when the unit is on, the Air Quality indicator will light up to show the current air quality:
2. To achieve better purif ication, make sure to keep the purifier 30 centimeters / 11.8 inches away
from walls, furniture and so on and at least 50 centimeters / 19.7 inches away from metals /
electrical appliances.
3. In sleep mode, press the Sleep Button once to check the current settings. Press twice to turn
off the sleep mode.
4. In automatic wind mode, the unit will adjust the fan speed according to the results read by the
dust sensor (dust concentration).
Change Filter Reminder
1. Change the f ilter when this indicator flashes.
2. Press and hold the ION Button for 3 seconds to reset the unit after Installing of the new f ilter.
Air Quality Indicator
Green
Orange
Red
Air Quality
Good
Moderate
Unhealthy
1) Unplug the power source
2) Remove the rear grille
3) Take out the old f ilter by pulling the tabs.
4) Install a new or the cleaned f ilter and put the rear grille back on.
5) Press and hold the ION Button for 3 seconds to reset the unit.
The Change Filter Reminder will turn off.
Filter
＞30cm
＞30cm
＞30cm
To Next Page
Loading...
Need help?
General