2
Getting to know your machine:
3
Getting started:
• IMPORTANT •
This unit is equipped with a
smart panel that senses your
touch. Heavy pushing of
buttons is not recommended.
BEFORE YOU BEGIN
Important: Remove all packaging covering the air purier and lters.
Make sure the lters are in place and correctly tted before turning on.
Stand the air purier on a hard at surface away from candles and ames.
Never block the air grills, keep air grills free from any obstruction
.
CHECK the air purier
for the lters. Be sure the
supplied lters are properly
in place and all plastic is
removed before turning the
unit on.
HORIZONTAL POSITION
PLACE the air purier on
a hard surface such as the
oor, a table or desk. Be sure
the grilles are not blocked by
other objects, and there are
no candles or ames near
the unit. The air purier can
be placed in a horizontal or
vertical position.
1 2
3
4
5
6
7
1 Air Purier Door: Easily remove to gain access to the lter at front
of machine.
2 Main Filter: Filter particles from the air that passes through the lter.
3 Odour Filter: Reduce odours from the air that passes through the
lt e r.
4 Side Intake Grill: Where air enters the unit.
5 Main Filter Light: Indicates the main lter may need to be replaced
when lit.
6 Odour Filter Light: Indicates the odour lter may need to be replaced
when lit.
7 Light Reset Button: This button resets both the main lter and odour
lter lights.
8 Timer: Set the run time for two, four or eight hours, before
automatically turning OFF.
9 Fan Speed: The fan runs at three speeds. The lights indicate the
current fan speed.
L: Low for the Silence Technology
®
M: Medium for typical use
H: High for maximum cleaning
10 Power: Turn the unit ON and OFF.
11 Exhaust Grill: Direct the ow of air as it exits the unit.
* Included in your machine: Main lter and odour lter.
Technical specications see page 9.
PLUG IN into nearest standard electrical outlet.
LIGHTLY TOUCH the power button to turn the air purier on. Touch
the power button again to turn the air purier o.
SELECT THE FAN SPEED. To select the speed, lightly touch and
release the fan speed button until the desired speed is reached.
L = low (Silence Technology
®
), M = medium or H = high.
ADJUST THE TIMER feature. The time can be selected from two,
four or eight hours. The unit will turn o once it runs for the
selected hours.
Note: The unit will run continuously if all the timer lights are o.
THE CHECK FILTER LIGHTS will light up when the lters may
need to be replaced. Touch and hold the button for several seconds
until the lter indicator shuts o.
FRONT