Vax C85-EW Series

*To purchase consumables and accessories, please visit vax.co.uk
Getting started
Assembling your vacuum cleaner
Using your accessories
Before you begin cleaning
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
CAUTION: Always switch o the vacuum cleaner before connecting or disconnecting the hose/attachments, or
removing and emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner o . If this happens, switch the vacuum cleaner o
and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour (if you have cleaned the  lters please wait 24 hours for the  lters to fully dry
before putting back into the machine).
Clean the pre-motor  lter every time the dirt container is emptied and replace the post-motor  lter every 12 months.
If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.
Press both buttons at the
end of hose and insert into
hose entry point.
Insert the other end of
the telescopic tube into
the  oorhead.
Insert hose grip into
telescopic extension tube.
Press button on telescopic
extension tube and adjust
to required length.
Push the accessory onto
the telescopic extension
tube or hose end.
The TurboTool connector
must be  tted on the hose
when using the TurboTool
(some models only).
Choose an accessory.