Vax CCQSASV1P1

Remove the bottom cover (B).
Clean out any debris or hair from
the brushbar and turbine fan.
Clean the TurboTool by removing the
2 screws (A), located on the bottom
cover, with a crosshead screwdriver.
Replace the bottom cover, insert
and tighten the screws.
B
A
CAUTION: To reduce the risk of injury from moving parts – unplug before servicing. The brushbar is equipped with
bearings which contain sucient lubrication for their lifetime. Do not add lubricant to the brushbar.
Removing blockages from the TurboTool
Taking care of your machine
IMPORTANT: Remove the accessory from the hose or telescopic extension tube before performing maintenance
or troubleshooting checks.
Let’s talk technical
!
40˚C
MAX
24hr
Cleaning the pre-motor lter
Twist the dirt container
lid anti-clockwise and
lift to remove.
Tap the lter over a
bin to remove any dirt
and debris.
Lift out the pre-motor lter. Rinse the lter under water
(40°C Max). Leave to dry
for 24 hours before placing
back in the machine.
Post-motor lter maintenance
Post-motor lter is located
in the right side wheel.
Hold the centre of the
wheel and twist the wheel
cover anti-clockwise.
Check the post-motor
lter for discolouration.
With the wheel cover o
the post-motor lter is
easily removed.
!
40˚C
MAX
24hr
IMPORTANT: The exhaust lter is designed to oer long life with no maintenance. The lter should be checked
periodically and when heavily discoloured it should be replaced. Please do not wash, scrub or brush the lter as
this will damage the delicate lter media.
Cable rewind button is located at the rear
of the machine. After unplugging, press the
cable rewind until the cord is fully retracted.
For convenience there is a parking slot located at the
rear of the vacuum cleaner where the oorhead and
tubes can be attached for storage and carrying.
Storing your machine
TIP
Clean the pre-motor
lter every time
the dirt container is
emptied and replace
the post-motor lter
every 12 months.
Remove the hose from the vacuum
cleaner and telescopic extension tube.
Remove any blockage by inserting a
wire coat hanger into the hose.
Removing blockages from the hose
TIP
To test for a blockage
in the hose, drop a
small ball of paper into
the hose. The paper
will drop through if
the hose is clear.