9
USING YOUR MACHINE
Filling the clean water/solution tank
Lift and pull to remove the
clean water/solution tank.
Fill the clean water/solution
tank with warm water (max
40°C) to the water fill line.
Twist the clean water/
solution tank cap
anti-clockwise to remove.
Replace the clean water/
solution tank cap and
twist clockwise to tighten.
Place the tank onto the
machine and push into place.
Pour the required amount
of solution to the solution
fill line.
Plug into the mains.
Press the On/Off pedal to
switch the machine on.
Press the handle release
pedal and pull the handle
backwards.
For best results apply
water/solution on the
forward stroke and
release the trigger on the
backward stroke to pick up
water/solution. Follow with
an additional dry stroke
with no trigger pressed.
Squeeze the trigger to
release the solution and
water mix.
Operation
To Next Page
Loading...
Need help?
General
