Using your machine
40C
Max
Fill the clean water
tank with solution mix.
Tighten cap before
returning tank to unit.
Unwrap power cord
and plug unit in.
Mix solution with warm
water (40°C Max).
Operating your pre-treatment wand
Turn the machine on.
Plug the pre-treatment
wand into the solution port.
Spray evenly onto
desired areas.
NOTE: Pre-treating your carpet before washing will help to remove stubborn stains. Leave pre-treatment solution to
work for 10-15 minutes. Before setting the machine to wash, ensure the clean water tank is rinsed thoroughly of pre-
treatment solution.
On rst use keep the button pressed down until solution is released.
To Next Page
Loading...
