V
ax Careline 0870 606 1248
17
maintenance/ storage
To replace brushes
Align posts on both ends of brush assembly with slots (D)
in cleaner housing.
Make sure that square post also aligns with square hole.
Turn brushes slightly until post fits easily into hole (Fig
6/4).
Press brush assembly firmly to snap into place (Fig 6/5).
7. Storage
Before storing:
Empty solution tank and rinse thoroughly with clean
water.
Replace empty solution tank and turn carpet cleaner ON.
Squeeze trigger and push carpet cleaner forward and back
several times to expel any solution remaining in the carpet
cleaner’s system. (Do not use carpet cleaner on wood
floors.)
Empty recovery tank and rinse thoroughly with clean
water.
Allow brushes and underside of carpet cleaner to air
dry thoroughly before storing carpet cleaner on a
carpeted or wood surface. Do not store carpet cleaner
with
Fig 6/4
Fig 6/5
Post
Post
Slot
Slot
Square post
Square hole
V-133 OasisComp User Guide v5.qxd:V-133 Oasis User Guide 8/9/08 14:44 Page 17
To Next Page
Loading...
