8
support.vax.co.uk
FILLING THE WATER / SOLUTION TANK
GETTING STARTED
Lift to remove the water/solution tank
from the back of the machine.
Unscrew the cap and fill to the desired
level using the markers on the tank.
IMPORTANT: Do not leave solution stored in the tanks between uses.
Replace the cap and push the tank
down on to the machine until it clicks
into place.
NOTE: When unpacking the machine, the water/solution tank cap will be attached to the side of the
tank. Before first use, and after water/solution has been added, ensure that the cap is screwed onto
the water/solution tank before refitting onto the machine.
LARGE AREA
SMALL AREA
SOLUTION
SOLUTION
WATER
WATER
To Next Page
Loading...
