7
operation/ maintenance
While making sure the dirty water tank is resting on the
base, place the rear of the tank into the base of the
cleaner, push down on the handle until it latches.
Replace lid of dirty water tank by pressing it into place
(Fig 4/16).
5. Maintenance
Brush removal and replacement
NOTE: The plug must be disconnected from electrical
outlet before cleaning or maintaining the appliance.
Ensure both clean and dirty water tanks are removed
from the cleaner.
Flip the cleaner on its side to expose the nozzle base.
Lift out the floating brushbar by pressing the two latches
and pulling it gently (Fig 5/1).
Replace floating brushbar (Fig 5/2).
Cleaning the tank filter
IMPORTANT: Do not use any detergents or boiling
water to wash the filters. Vax recommends
checking the filters every time the dirty water tank is
emptied.
NOTE: All filters must be in place before using your
machine.
Remove the dirty water tank from the unit.
Remove the filter cover from the back of the tank.
Separate the filter from the filter cover.
The filter can be rinsed in warm water (max. 40
°C)
IMPORTANT: Ensure filter is fully dry before
replacing back into the machine.
Fig.4/16
Fig.5/1
Fig.5/2
To Next Page
Loading...
Need help?
General
