5. Rinse the dirty water tank and filter thoroughly with
lukewarm (max 40ºC) water. Allow to air dry fully
before replacing them into the cleaner to prevent
mildew (Fig.6/5).
NOTE: Do not use any chemicals in the cleaning
process.
6. Lift the front of the carpet washer base off the
carpet with one hand (Fig.6/6).
7. Replace the dirty water tank by hooking the front
of the dirty water tank into the base of the cleaner,
making sure the the front of the dirty water tank is
resting on the base. The dirty water tank has two
(2) tabs on the underside which MUST latch on to
the underside of the base of the cleaner. Failure to
install the dirty water tank correctly will result in
poor dirt water pick up (Fig.6/7).
Fig.6.7
Fig.6./6
Fig.6/5
8. While making sure the dirty water tank is resting
on the base, place the rear of the tank into the
base of the cleaner and push down until it clicks
into place (Fig.6/8). Empty and rinse the clean
water tank after use.
7. Storage
Carry handle
Grasp the carry handle located on the clean water
tank cover to move the carpet washer from room to
room (Fig.7/1).
BEFORE STORING CARPET WASHER:
1. Empty and rinse clean water tank and dirty
water tank.
2.
Replace empty clean water tank and dirty water
tank.
3. Ensure that brushes and underside of unit are fully
dry prior to storing on a carpeted or
wood surface.
NOTE: Do not store or transport unit with a full clean
water tank or dirty water tank.
Fig.7/1
Fig.6/8
E
mptying the Dirty Water Tank/Storage
7
Vax V-022(Q).qxd 23/8/06 11:47 Page 7
To Next Page
Loading...
Need help?
General
