Taking care of your machine
Remove both tanks and tilt
the carpet washer so its
lying on its back.
Hook the tank release
catch over the front of the
tank and push downwards
to lock the catch in place.
Lift the nozzle release clip
to unlock the nozzle.
Hold the front of the
nozzle and push down to
release the nozzle away
from the washer. Once
released, lift to remove.
Rinse nozzle under water
(40°C max) to remove dirt
and debris.
To re-t, slide the dirty
water tank onto the carpet
washer, making sure
the tabs on the tank line
up with the back of the
washer.
Removing and cleaning the nozzle
To replace the nozzle, hook the tabs on nozzle
with the front of carpet washer and slide the
nozzle into place.
Push the nozzle release
clip to lock the nozzle.
Lift and hook the latch
on the tank onto the lid
and push down to lock
into place.
To prevent excessive build up of dirt
/debris in the nozzle, always dry
vacuum before using the carpet washer.
TIP
To Next Page
Loading...
Need help?
General
