Taking care of your machine
Cleaning the post-motor lter
Cleaning the lter and separator
Press the lter cover
release buttons located
on both sides of the lter
cover and pull to remove
the lter from the machine.
Turn the handheld
over and press the dirt
container release button.
Pull the dirt container
forward and up away from
the handheld to remove.
Twist the mesh lter
anti-clockwise to
unlock, lift to remove
from the separator.
Twist the separator
anti-clockwise to
unlock, lift to remove
from the handheld.
Leave for 24hrs or until
fully dry before replacing.
Pull to separate the lter from the lter cover/holder.
Tap the lter and lter cover/holder over a bin to
remove any dirt/debris. Wash the lter under running
water (40 degrees max).
CAUTION: Always remove the battery from the vacuum cleaner before performing maintenance or troubleshooting
checks. For continuous best performance the lter requires cleaning every 3 months and should be replaced every
12 months depending upon use. Do not use your vacuum cleaner without the lters in place.
CAUTION: Always empty the dirt container before cleaning the separator and lter and remove the battery,
reach wand/accessories from the handheld.
24hr
To Next Page
Loading...
