Let’s talk technical
Removing blockages from the Powered Head
The brushbar should be removed from the Powered
Head before attempting to remove any blockages.
Using scissors remove any threads or hair from
around the brushbar and clear any dirt or debris
from Powered Head.
IMPORTANT: If the brush bar has been obstructed, the motor protection sensor may have been activated, the light
will ash Red and the brushbar will seize. Remove the Powered Head from the machine and clear any obstruction.
Ret the Powered Head, switch on the vacuum cleaner by pressing the trigger and press the brushbar On/O button.
Removing and replacing the brushbar
Slide to release the
brushbar. The cover
can not be removed.
Lift to remove the left side
of the brushbar rst.
Clear any threads or hair
from both ends of the
brushbar and any dirt/
debris inside the housing
of the Powered Head.
When re-tting the
brushbar t the right side
into the housing rst.
Then line up and slot into
place the left side.
Removing blockages from reach wand
To test for a blockage in the reach wand, drop a small
ball of paper into the wand. The paper will drop through
if the wand is clear. Use a broom handle or similar blunt
object to remove any blockage.
Cleaning terminals
Using a dry cloth or
soft dusting brush remove
any dust/debris from
terminals on battery
and inside the handheld.
To Next Page
Loading...
