Getting started
Fixing the wall bracket
PLEASE READ ‘LET’S TALK SAFETY’ BEFORE USE
Fully assemble the
vacuum but do not
attach the battery.
Use both screws and wall
plugs to secure the wall
bracket to the wall. Place
covers over the screws.
Attach the wall bracket
to the handle.
Firmly press the vacuum
handle into the wall
bracket to secure.
With the wall bracket
attached, stand the
vacuum close to the wall,
in the upright position
with the Powered Head
at on the oor.
Holding the wall bracket
rmly in place, carefully
remove the vacuum. Using
a pencil make a small
mark for each screw.
CAUTION: The battery used in this device may present a risk of re or chemical burn if mistreated. Do not
disassemble or heat above manufacturer’s maximum temperature limit (60° C/140°F) or incinerate. Replace
battery with Vax battery only. Use of another battery may present a risk of re or explosion. Dispose of used
battery promptly. Keep away from children. Do not disassemble and do not dispose of in a re. Do not attempt to
disassemble the battery or remove any component projecting from the battery terminals. The battery and charger
have no user serviceable parts. Fire or injury may result. Prior to disposal, protect exposed terminals with heavy
insulating tape to prevent shorting. Remove the battery from the appliance before it is disposed of safely at your local
battery recycling centre.
For best performance, the terminals on both the battery and the appliance must be clean and free from dust and dirt.
Do not attempt to recharge non-rechargeable batteries. The battery must be removed from the appliance before it
is scrapped. The appliance must be disconnected from the charger before use and when removing or installing the
battery into the machine. In case of battery leakages avoid any contact with the skin. Contact our Customer Care Line
on 0800 092 7737.
To Next Page
Loading...
