10
USING YOUR MACHINE
Operation
Select the desired tool
attachment.
Plug the machine into the
mains and switch on.
Unclip the wash tool and
lift the hose out of the clips.
Unwrap the cord from the
quick cord release hooks.
Press the trigger on the
wash tool to release
water and solution.
Press the on/off button to
switch the machine on.
For spills, always pick up
the excess liquid before
using water/solution.
Tilt the tool forward on to
the spill and pull back.
Fit the front of the selected
attachment into the front of
the wash tool and push the
clip down to click into place.
Use the brush to agitate
any stubborn stains.
Release the trigger and tilt the
nozzle forwards so the nozzle
is in contact with the surface.
Pull back to recover the water
and solution.
Multi-purpose Attachment
For cleaning carpets, rugs,
sofas and upholstery.
Hard Floor Scrub
Attachment
For cleaning tiles and
sealed wooden floors.
2
21
1
IMPORTANT: Over or under tilting the hand tool may result in poor water pick up.
To Next Page
Loading...
Need help?
General
