3
• Don’t use the machine with incorrect voltage as this may result in damage or
injury to the user. The correct voltage is listed on the ratings label.
• Don’t over saturate your flooring/surface. Always finish on a dry stroke.
• Don’t use on a surface that is damaged, uneven or incorrectly fitted.
DO’S
Refer to the floor/surface manufacturer’s care recommendations before use.
Test your flooring/surface - run the machine over a small hidden area, if no
damage or discolouration occurs continue cleaning. Not suitable for use on
water sensitive flooring/surfaces.
• The clean water tank should be filled with warm water (max 40°C) only. Filling the
clean water tank with hot or boiling water will damage the machine and invalidate
the guarantee. Always use the machine with all water tanks and filters in place.
• Always keep the area you’re cleaning well lit.
• Always replace the fuse in the plug with a British 13amp fuse.
• Always unplug the machine before carrying out any maintenance and before
connecting or disconnecting the accessories.
• Take extra care when cleaning on the stairs.
• Turn off all controls on the machine before disconnecting or connecting the power
cord. After use always wrap the power cord around the cord clips provided.
• Always protect the power cord from heated surfaces and open flames.
• Use only CE approved 13amp extension cords, non-approved extension cords may
overheat. Care should be taken to arrange the extension cord as it can be a trip
hazard.
• Keep all openings clear and free from debris as this may affect the airflow/
suction/water pick up.
• Always use the machine in an upright position. To prevent motor damage from
dirty water, never hold the machine upside down or on its side.
• Store the machine in a cool, dry area. Before storing the machine please ensure
all water/solutions tanks are empty and filters are thoroughly clean and dry.
To Next Page
Loading...
Need help?
General
