Getting started
Assembling your cordless vacuum cleaner
Lift the handle in a hinge like manner and line up with
the main body. Make sure the cable attached to both the
handle and main body is inside the main body and does
not become trapped. Push the handle down into the
main body until it clicks securely into place.
Fix the wall clip to your wall using the screw and wall plug provided. During storage
and charging, secure your vacuum cleaner handle into the wall clip.
Line up the oorhead
and main body. Push
the main body down
onto the oorhead to
secure into place.
Push the main body
forward to lock the
oorhead into place.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Before you begin
CAUTION: Always switch o the vacuum cleaner before connecting or disconnecting the charger or removing and
emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner o.
Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to cool
for approximately 1 hour (if you have cleaned the lter please wait 24 hours for the lter to fully dry before putting
back into the machine).
For best cleaning results, lters require cleaning every 4-6 uses or as needed depending upon use. (Refer to ‘Taking
care of your machine’ – Cleaning the lter).
If the vacuum cleaner is blocked, switch o before removing the blockage.
CAUTION: This vacuum cleaner has a constantly rotating brushbar. Never leave the vacuum cleaner in one spot for
an extended period of time as this may damage the oor surface.
CAUTION: Take extra care when assembling the handle. Make sure the cable is correctly inserted inside the main
body and does not become trapped between the main body and handle.
To Next Page
Loading...
