Looking After Your Machine
10
vax.com.au
vax.co.nz
The belt
Lubrication
Brushroll maintenance
Replacing the brushroll
Motor protection / Vacuum shutdown
The Vax Magnesium™ is equipped with the Endurolife™ Belt, which is designed for long life and doesn’t need changing.
The vacuum motor bearings are factory lubricated and sealed. Further lubrication is not required.
At least once a month, check for and remove excessive lint, string or hair from the revolving brushroll.
Patented cleaning grooves on the brushroll will allow easier cleaning. Wipe the outside of the vacuum
with a damp cloth. Also clean the connector deector assembly area, base of vacuum and fan housing
area. If there is dust in the outer bag, vacuum it or shake it out. A little preventative maintenance will
keep your upright vacuum looking new and will ensure continued cleaning eectiveness.
The brushroll is designed for long life. Should it ever become worn or frayed, it can be replaced by an Vax Authorized
Service Agent on AU 1300 361 505 / NZ 0800 800 900 or vax.com.au / vax.co.nz
If the vacuum becomes overloaded (which could occur when a large obstruction is sucked up or when vacuuming extremely
thick carpet), the electronics are designed to shut down the vacuum. If this happens, the vacuum will automatically shut o and
the headlights will ash. To reset the vacuum, turn the unit o, wait 5 seconds, and then turn it back on. If it shuts down again
there may be a large obstruction in the vacuum. See “Stung or Blockage” for the steps on clearing a blockage.
WARNING: Unplug cord from electrical outlet before servicing.
NOTE: The performance of your Vax Magnesium
TM
new vacuum greatly depends upon care and maintenance.
The instructions in this manual will guide you in performing basic care and maintenance. To ensure the most satisfying
years of service read the instructions and keep them handy for future reference.
To Next Page
Loading...
