Taking care of your machine
Operating the appliance
Removing blockages from the Turbobrush
Locking ring
To re-assemble the TurboTool,
ensure that the tabs are engaged
and pivot the lower housing
closed. Slip the locking ring over
the neck of the TurboTool and into
the groove to nish.
Turn the TurboTool over and slide
o the locking ring.
Switch the vacuum cleaner o
and disconnect the power plug
from the electrical outlet.
Lay the Turbobrush on a at
surface and turn over to expose
the brushbar. Using a pair of
scissors, cut through any threads
or hairs caught around the
brushes and brushbar.
Detach lower housing and
remove blockage.
To Next Page
Loading...
