21
ELCARE NORDIC: service.vaya@elcare.com
CHARGER SPECIFICATIONS
Standard charger 48 V
Model number: DPLC165V55-M
Input: 110 – 240 V, 3 A, 50/60 Hz
Output: 54.6.0V
3.0 A
INSPECTION, MAINTENANCE, AND STORAGE
Your e-bike requires routine inspection and maintenance. This chapter describes
maintenance steps and important operating tips. Before you perform the following
operations, ensure the power and charging cable is disconnected.
The bicycle (e.g. non-electrical) parts of the e-bike are standard components that can
be obtained from your local bike shop. Ensure that replacement parts are genuine parts.
Contact customer support if in doubt.
Use of non-genuine or non-compatible parts, or modication of the bicycle outside its
specications is considered tampering. Tampering may result in increased risks to the
user, and the user bears responsibility for any resulting issues.
INSPECTING YOUR E-BIKE
Routinely check the frame and tyres of the e-bike for damage or excessive wear and for
correct tyre pressure, check all bolts and screws and tighten them if needed.
Check that the handlebar screws are secure. Check that the handlebar cannot be moved
up and down.
Check the side of the front and rear wheels for correct tyre pressure. See markings on
tyres for correct tyre pressure.
The rims are subject to wear, which must be checked to ensure safety.
Check the brake pads for wear. If they are worn (approx. 1 mm left), replace the brake
pads immediately.
See service folder for more information.
See the photo below, where screws must be checked and secured after each ride.
To Next Page
Loading...
