Vaya FB-2 - Page 23

23
ELCARE NORDIC: service.vaya@elcare.com
Step 2:
When lifting the rear of the bike and turning the pedals by hand, use the gear change to
select the highest gear.
Use a suitable screwdriver to turn the screw marked “H” (high gear) to adjust the rear
derailleur until it is vertically aligned below the highest gear. See the photo above.
Step 3:
When lifting the rear of the bike and turning the pedals by hand, use the gear change to
change the highest to the lowest gear one at a time. If the derailleur is adjusted correctly,
the gears should shift quickly without any grinding noise.
If there are still problems after you adjust the rear derailleur, you can ne-tune it.
Rotate the adjuster (C) clockwise if there is a problem going from the lowest to the
highest gear.
Rotate the adjuster (C) counter-clockwise if there is a problem going from the highest to
the lowest gear.
Turn the adjuster about a quarter turn at a time and then change the gears to see if the
problem is xed. Repeat step 3 if the problem persists.