9
3.3. Switch the machine ON
Switch the Power button ON : the orange light will turn on. The boiler water inlet and the element will
automatically start; once the boiler is lled the Red Heating Element Activity Lamp is informing the element is
worming up.
Wait until the Red Heating Element Activity Lamp turns off, then check on Brew Pressure Gauge (right side of
the machine) that boiler pressure is about 0,9 - 1,1 bar.
In this phase it is necessary to open both the Steam Valves and let the air inside the boiler go out.
IMPORTANT: the boiler water lling is protected by the time-out function (120 seconds), once this time is elapsed
water lling automatically stops: touchpads leds start blinking. Then it is necessary to repeat all instructions from the
beginning – SWITCH THE MACHINE ON –
To use cup warmer switch the Cupwarmer button ON
To Next Page
Loading...