Connect the antenna to the VBOX HD Lite and insert the SD card.
Connect the Wi-Fi dongle to use the VBOX HD Lite Preview App to adjust the camera settings.
Power
VBOX HD Lite is powered by the supplied cigar Lighter power supply cable (RLCAB165). Plug it in the vehicle's 12 V
cigar power socket and connect it to either of the Hirose connectors at the rear of the unit. The device will boot up
automatically as soon as the power supply is connected.
On boot-up, you will hear three beeps in quick succession followed by a single beep. The LED will briefly flash red, then
show solid white throughout the boot-up procedure. When the LED is solid green, the device is booted up and ready to
record.
For any other LED behaviour, see the Status LED behaviour table.
Connectors
You can find more detailed connector information on the PIN-OUTS page.
Rear
• 2 x 6-pin Hirose connectors for power and CAN /
Serial.
• GNSS Antenna.
8
To Next Page
Loading...