•
Press the left ‘SPEED +/-’ knob to set the horizontal vibration speed. Rotate to
adjust.
•
Press the right ‘SPEED +/-’ knob to set the linear vibration speed. Rotate to
adjust.
•
Press ‘PROG’ to confirm settings.
•
Repeat as needed until the program is set to your satisfaction.
10. The standby button will pause the machine. Press the start/stop button to
resume.
11. The mode selection knob lets you choose between the different program modes
(P1-P3, U1-U3) by rotating the knob.
12. The time up button increases the time. The starting default time is ten (10)
minutes and the maximum adjustment is twenty (20) minutes.
13. The time down button decreases the time. The starting default time is ten (10)
minutes and the maximum adjustment is twenty (20) minutes.
To Next Page
Loading...
