VDIAGTOOL V200 - Warranty; Limited One Year Warranty; Service Procedures

To Next Page

To Previous Page

conducting full battery current to the tip of the probe. There is a nice safety feature

built into the tool. Simply connect the extra ground lead to the tool and press the

power switch forward until it trips the circuit breaker. This will prevent power from

going to the tip but still allow you to use the tool as a multimeter. When you are away

from computer components, simple press the reset button and you are ready to

power up again.

This warranty is expressly limited to buyer who purchase VDIAGTOOL V200 product

for purposes of resale or use in the ordinary course of the buyer’s bussiness.

VDIAGTOOL V200 is warranted against defects in materials and workmanship for

one year (12 months) from date of delivery to the buyer. This warranty does not cover

any part that has been abused, altered, used for a purpose other than for which it

was Intended,or used in a manner inconsistent with instructions regarding use.

The exclusive remedy for any tool found to be defective is repair or replacment, and

it shall not be liable for any consequential or incidental damages

6.1 Limited One Year Warranty

6.2 Service Procedures

6. Warranty and Service

Trademarks

VDIAGTOOL is the trademark of Shenzhen vdiagtool Technology Co., Ltd

All other marks are trademarks or registered trademarks of the respective holder.

All rights reseed

Disclaimer

The information, specications and illustrations in this user manual are based on the latest

information available at the time of printing.

VDIAGTOOL resees the right to make changes at any time without prior notice.

Warranty & Suppo

E-Mail: suppo@vdiagtool.com

Website: www.vdiagtool.com

For wholesale business or become our distributors:

E-Mail: sales@vdiagtool.com