Entering
CONFIG
0/1/2/3
[RETURN]
allows
you
to
select
from
these
four
different
options.
For
example,
to
choose
to
print
from
List
Device
2,
enter
the
command:
CONFIG 2 [RETURN]
The
program
will
"select"
and
"attach"
the
system, and adjust
its
settings
to
send all printer-bound
instructions
to
the
printer
set
up
as
Printer
2
(the
Vector 'tWO in standard systems).
If
you would like
the
screen
to
prompt you with
the
available options, you
can
also
enter
the
command:
CONFIG [RETURN]
This will make
the
screen
respond with:
VECTOR
4 CP/M CONFIGURATION PROGRAM YER.
1.X
PRINTER SELECTION
(0]
DISCARD PRINTOUT
[1]
LIST DEVICE 1 -
<eurrent
setting>.
[2]
LJST
DEVICE 2 -
<eurrent
setting>
[3] ROUTE PRINTER OUTPUT TO
SYSTEM
CONSOLE
ENTER SELECTION
(I):
(where
the
(#)
indicates
the
present
selection). Entering each
of
the
options
will have
the
following result:
[0] DISCARD PRINTOUT
Choose
this option
if
you do
not
have a
printer
connected
to
the
system.
In
addition,
some
applications
programs
(such
as
Vector
Graphic's
MEMORITE III)
handle
selecting
and
attaching
the
printer
directly,
and
the
printer
cannot
be
attached
using CONFIG. (See
the
specific
program
manual for information on printers.)
IX-I
0
[1] LIST DEVICE 1 or [2] LIST DEVICE 2
Enter
either
[1]
or
[2],
depending on
the
printer
you would like
to
use.
On standard Vector 4 systems,
Printer
1 is
not
used, and
Printer
2 is
the
Vector 7700
letter-quality
printer.
7100-0001
09-01-82
- Rev. A
To Next Page
Loading...