VECTOR 4 USER'S MANUAL
VECTOR 4 CP/M
TRANSIENT COMMANDS
[3] ROUTE
PRINTER
OUTPUT TO
SYSTEM
CONSOLE
This
option
sends
the
printout
to
the
terminal. You will probably use
this only
if
you
are
training
in
the
commands
for
printing,
while
no
printer
is
attached
to
the
system.
Once
you
have
entered
the
number
of
the
option you want,
the
screen
will
display
the
A)
prompt,
indicating
that
Vector
4
CP
1M
has
returned
to
command
level.
If
some
other
program
is using
the
printer,
the
screen
will
display
the
message:
PRINTER IS BUSY
Wait
for
the
other
program
to
end,
or
reboot and run
the
CONFIG program
again,
selecting
0
to
clear
the
system,
then
one
more
time
to
select
the
desired
printer.
Configuring Floppy Drives
The command
to
configure floppy drives is CONFIG F [RETURN].
This
option
allows
you
to
set
your
floppy
disk
drives
for
single-
or
double-sided
configuration.
Each drive may
be
set
individually;
it
is thereby
possible
to
set
up
the
computer
with
one
lQtical disk drive for single-sided
diskettes,
and
another
drive for double-sided (even
if
you only have one
actual
physical
slot
to
insert
your diskettes).
1.
When
you
see
the
A)
prompt,
enter
CONFIG F [RETURN]. The
screen
will display:
FLOPPY DISK CONFIGURATION (SINGLE/DOUBLE)
SET DRIVE
d:
TO
[8] SINGLE OR
[D]
DOUBLE - (D):
2.
This
line
will
display
for
each
available drive (listed
as
d:
in
the
above
example)
currently
supported
by
your
system.
Set
up
diskette
configuration according
to
the
following:
Press
[8]
to
set
drive
to
single-sided.
Press
[D]
to
set
drive
to
double-sided.
Press [RETURN]
to
leave
drive
as
indicated on screen.
Rev. A -
09-01-82
7100-0001
IX-11
To Next Page
Loading...