VECTOR GRAPIDC, INC.
(In
the
example above,
58
+ 3 = 61).
The remainder will
be
the
lower margin.
b.
the
total
number
of
lines
per
page equals
the
number of lines per
inch used by your
printer
times the number of inches per page, or:
Length of page (in inches) X Lines per inch
= Line 1
(If
the
printer above prints 6 lines per inch, then
the
setting
above
is
correct
for
ll-inch
paper, since
11
X 6 = 66).
3.
For
the
auto-paging
prompt,
select
either
"enabled"
or
"disabled" as
the
actual
printing routine will determine the location of page breaks.
4. The
screen
will display:
PRESS [RETURN] TO CONFIRM SELECTION OR [ESC] TO ABORT:
Again,
you
have
a
"last
chance"
to
get
out
of
this
program without
changing any values. Enter the appropriate key
for
your choice.
NOTE
The
CONFIG 0 program will not check for impossible,
or
even unsightly, page
specifications. Be sure to check the values carefully.
If
you wish
to
make a more
certain
and permanent change
to
your
list
device
driver,
consult
the
Vector.
4. CPLM, Prqrraromec's Guide (PIN 7100-0003). The
GENLIST command explained
there
lists
the
various printer driver files which
may be available to you.
Some
of these can be assembled with
optional
page
sizes.
IX-16 7100-0001
2-01-83 - Rev. B
To Next Page
Loading...