Vector Graphic Vector 4 - Page 147

VECTOR 4 CP/M TRANSIENT COMMANDS
The CONFIG B Option
This option allows you to adjust (temporarily) the baud rate, which is the
speed (in bits per second) at which the printer and/ or modem rec eive
instructions from and send data to the central processing unit. This probably
should not
be changed unless you are using an applications program (such as a
telecommunications program) which requires sending information at a specified
baud rate.
To determine and (if necessary) adjust the baud rate for your printer and/or
modem, enter:
A)CONFIG B [RETURN]
The screen w ill display:
VECTOR 4 CP/M CONFIGURATION PROGRAM VER. 2.X
BAUD RATE SELECTION
CURRENT
PRINTER BAUD RATE IS ff".
[1] 110
[3] 300
[5] 1200
[1] 4800
[2] 150
[4] 600
[6] 2400
[8] 9600
SELECT NEW BAUD RATE PROM ABOVE:
Enter the number corresponding to the baud rate specified by the program
which requires the change, or press [RETURN] to accept the current rate.
The screen will then display: .
CURRENT
MODEM BAUD RATE IS Ilfl.
[1] 110
~~~ [3]300
f:: [5] 1200
['1] 4800
[2] 150
[4] 600
[6] 2400
[8] 9600
SELECT NEW BAUD RATE PROM ABOVE:
Again, select the number corresponding to the baud rate desired by the modem
program, or press
[RETURN] to accept the current rate.
Rev. A - 09-01-82
7100-0001
IX-17