VECTOR GRAPmC, INC.
V-I 0
Although your Vector 4 is designed
to
use a Vector
7700
letter-quality printer,
it
has the built-in capacity
to
use several
other
types
of
printers.
In
fact,
you
can
connect two
different
printers
to
your Vector 4
at
the
same time.
Remember
the
banner you
see
when the system boots:
VECTOR
<I
CP/M
VERSION
LX
PRINTER 1
LOADED
WITH
<current setting>
DRIVER
PRINTER 2
LOADED
WITH
<current
setting)
DRIVER
A)
This indicates
that
this capacity is built into your system.
But
to
use
the
printer,
you must
tell
the
operating
system
which
one
is
connected.
To do
that,
use
the
CONFIO
<I>
option.
It
must be used every
time you wish initialize the printer. Make sure the printer is turned
on
before
you do this.
The
<.>
here
stands
for
one of four possible options. To see them, you can
enter
CONFIG [RETURN]. The screen will display:
VECTOR GRAPmC
SYSTEM
CONFIGURATION
PROGRAM
VER. 1.X
[0] DISCARD PRINTOUT
[1] IJST
DEVICE
1 - <current setting>
[2] IJST
DEVICE
2 - <current setting>
[3] ROUTE PRINTER OUTPUT TO
SYSTEM
CONSOLE
ENTER SELECTION
<I):
Here is an explanation of
all
four options:
DISCARD PRINTOUT
If
you do not have a
printer
connected
to
the system,
set
the
CONFIG P
option for [0]. In addition, some applications
programs
(such as
Vector
Graphic's
MEMORITE
Ill) handle selecting the printer directly.
LIST
DEVICE
1
or
LIST
DEVICE
2
Enter
either
[1]
or
[2], depending
on
the
printer you would like
to
use.
The
Vector
7700
is
set
to
operate as Printer 2.
PIN
7100-0001
2-01-83 - Rev. B
To Next Page
Loading...