VECTOR 4 USER·S
MAlt
UAL
VECTOR 4 OPERATING
COMMANDS
ROUTE PRINTER OUTPUT TO
SYSTEM
CONSOLE
This option sends
the
printout
to
the
terminal.
You
will probably use
this only
if
you are testing a
new
printer driver
or
if
you
are training in
the commands for
printi~.
Once you
have
entered
the
number
of
the
option you want, the screen will
display:
PRESS [RETURN] TO CONTINUE OR [ESC] TO
ABORT_
If
for any reason you
do
not wish
to
change the
setting
at
this
time,
simply
press
the
[ESC]
key. The prompt for the drive on which you
are
logged will
appear.
To make
your
selection, press [RETURN].
If
the
printer you have selected is
in use
by
another program,
the
screen will display:
PRINTER IS
BUSY
If
the printer is off or not properly connected, you will
see
the message:
PRINTER IS NOT OPERATIONAL
Make
sure
that
the
printer is connected
to
your system,
to
the power source,
and turned on before seeking service.
!
If
the printer is free, the screen will display:
OPTION SELECTED
The screen will display:
VECTOR 4
CP
1M
VERSION
1.x
PRINTER 1 LOADED
WITH
A DRAFT DRIVER
PRINTER 2 LOADED
WITH
A
WORD
PROCESSING DRIVER
e:::::~~
A)
Rev. A - 9-01-82
PIN
7100-0001
V-II
To Next Page
Loading...