VECTOR .. USER'S
MANUAL
VECTOR .. OPERATING
COMMANDS
INSERT
DESTINATION DISKETTE AND PRESS
THE
[RETURN]
KEY
WHEN
READY:
4.
Press
[RETURN] when you have inserted and mounted
the
diskette in the
drive. The screen
wD.l
display:
DO
YOU
WANT
THE
VECTOR
SYSTEM AND LIST DEVICE FILES
COpmDT
[y]
OR [N]:
Enter
Y
if
you intend
to
boot from the newly-generated system diskette.
If you enter N, you will not be able
to
use
the
diskette for booting.
5.
The screen will display:
INSERT
SOURCE
DISKETTE AND-
PRESS
THE
[RETURN]
KEY
WHEN
READY:
If
you
are
using
the
same physical drive, remove the destination diskette
from the drive and insert the
source
diskette.
Press
[RETURN].
The
drive
will
access
as
indicated
by
the
red
light. Then the screen will
display:
INSERT
DESTINATION DISKETTE AND
PRESS
THE
[RETURN]
KEY
WHEN
READY:
6.
Again, remove
the
source
diskette
from
the drive and insert the backup
diskette.
When
you
press
[RETURN],
the
drive
will
click
again.
The
screen will display:
VECTOR.CPM FILE
COPmD
TO DESTIHATION DRIVE
VECTOR.LDl FILE
COpmD
TO DESTINATION DRIVE
VECTOR.LD2 FILE
COpmD
TO DESTINATION DRIVE
GENSYS.COM FILE COPmD TO DESTIHATION DRIVE
7. The screen will display:
SYSTEM
GENERATION COMPLETED
You now
have
a
backup
of
the
operating system. If you lose or damage
the
System diskette, you
can
boot from the newly-made
diskette.
However,
you
will
still
have
to
copy
the
Transient
Commands (such as
STAT
and PIP),
as
well as any other programs you use, onto this disk
before
you
can
use
it
for
all your work.
Rev. A - 9-01-82
PIN 7100-0001
V-17
To Next Page
Loading...