Vector 4 - Page 147

VECTOR GRAPHIC, INC.
3.1.1 Interrupt Commands
In this activity, the following interrupt commands can be used to quit the
program or to input new parameters:
[ESC] Exits to CP/M (to system monitor on non-extended CP/M -
systems - not applicable to Vector 4 SBC systems).
[SPACEBAR] Returns to parameter input prompt (as in Step 3, next page).
| From this point, it is possible to enter new parameters as
prompted, or to enter [RETURN] to accept default values. All
interrupt commands can be entered at this time, as well.
[CTRL CI] Exits to CP/M (all systems).
? Displays help screen of possible DISKTEST commands.
3.1.2 Running DISKTEST While Checking Drive Alignment
The following procedure describes loading the DISKTEST software, the
commands to initiate a testing loop, and the commands to switch between
read/write heads. Familiarize yourself, if necessary, with this section before
proceeding to Section 3.2.
For additional information, refer to Vector Graphxc s DISKTEST ope=rat1ng
manual.
1. With system set up and running as described for checking drive alignment,
insert test diskette into drive to be checked.
If testing two-floppy system, load known good floppy containing the file
DISKTEST.COM into drive not being tested.
If testing system with hard and floppy drives, make sure that the file
DISKTEST.COM exists on hard drive,
2. Log onto drive containing software and enter DISKTEST [RETURN]
Press Y to continue the program, then correct number (as indicated on
screen) to select floppy drive for alignment.
a1 3-2 7200-0001 09-01-82