Vector 4 - Page 148

VECTOR 4
TECHNICAL INFORMATION
In the following step, XXX represents a three-digit number from 000 through
076, and XX a two-digit number from 00 through 15. Entering all three digits
makes a [RETURN] unnecessary. To enter a number lower than the maximum
number of digits, either pad the entry with zeroes, or enter the number
followed by a [RETURN]. To use the default values assigned by the program,
enter only a [RETURN] for the prompt. \
3.
09-01-82
Answer the prompts where indicated by underlined responses. In actual
use, head and track specifications will change as different parts of the
drive are checked. To correct an improperly-entered response, press the
[SPACEBAR] to return to the top of the prompt list.
SELECT OPERATION (? FOR HELP): RT
SELECT UNIT: (0 THRU 3) 1
SELECT HEAD: (0 THRU 1)
SELECT TRACK: (0 THRU 76) XXX
SELECT SECTOR: (0 THRU 15) XX
ENABLE ECC LOGIC ?2 (Y OR N: Y
ENABLE ECC CORRECTION ? (Y OR N) N
ENABLE AUTO DUMP ? (Y OR N) N
If you wish to respecify any parameters once the operation begins, press
[SPACEBAR] to interrupt program. Enter new values as desired; to pass
a parameter without changing, simply press [RETURNL
To toggle between the two heads of the drive, press H. This switching
‘between heads of the drive will allow a proper cat's-eye comparison.
To verify location on the disk, enter C. This will display current
location of the read/write head on the alignment diskette.
7200-0001 I 3-3