© 2004 VECTOR MANUFACTURING, Ltd.
FT. LAUDERDALE, FL 33312
MADE IN CHINA
REV082704
TROUBLESHOOTING GUIDE
Jumpstarting
:
A) Make sure switch is “ON” position.
B) Make sure jumpstart has a full charge.
C) Make sure there are proper polarity connection.
12 volt outlet usage:
If 12 volt outlet fails to deliver power to 12 volt items, do the following:
A) Make sure there is a proper 12 volt adapter connection.
B) Make sure jumpstart has a full charge.
C) If unit shuts off, disconnect 12 volt outlet and let cool for 10 minutes
Note: When pulling more than 12 amps from the 12 volt outlet, unit will shut off.
LED area light:
If area light does not come on when pressed, charge jumpstart.
When charging through AC/DC cords, the red charging light should turn on. If it does not, do
the following:
A) Check AC or DC connection for a firm connection.
B) Check AC or DC voltage from power source.
C) Make sure unit is in “off’ position before charging.
To Previous Page
Loading...
Need help?
General
