Vector TCY3-T1102 Series - User Manual

TCY3-T1102
Doc: 70-000003 V1.0, 20150710 © Vector Controls GmbH, Switzerland Page 1
Subject to alteration
TCY3-T1102 Series Intelligent Compact Controller
Features
 Temperature control for 2-pipe, 4-pipe HVAC
systems.
 -H version: humidity control with integrated
humidity sensor
 Universal PID and binary control for any
analog input/output signal and range
 4 independent PID sequences
 2 modulating outputs for DC 0...10 V or
0…20 mA actuators with 10 bit resolution.
 1 input for DC 0…5 V, 0…10 V or 0…20 mA
sensors with 10 bit resolution
 1 internal temperature sensor and 1 external
sensor input
 1 binary input for open contacts for auto
changeover, remote control, alarm and more.
 Monitoring of low and high limits on all inputs.
Programmable reaction in case of alarm.
 Feedback functions for internal sensors and set
points.
 Special functions for dehumidifying, set point
shift and VAV control
 Transformation of display value according to
analog sensor range
 Password protected programmable user and
control parameters
 Blue backlight
 Deluxe version only:
o Power cap protected real time clock with 24h
power backup
o 16 switching times, grouped in 4 time
schedules.
o Infrared remote control
Applications
 Air only systems: constant or variable air volume systems for single or dual duct systems with options of:
o supply air, extract air cascade control
o humidity control
o control for variable speed fans
 Air/water systems:
o radiator control,
o chilled ceiling
 Water only systems: radiator, floor heating or chilled ceilings
 Analog interface for building automation systems
 Individual room control for hotel rooms, meeting rooms, etc.
General description
The TCY3 is a stand-alone electronic universal controller with two autonomous control loops. Each control loop may use up
to 2 PID sequences. The TCY3-T1102 features 1 NTC temperature sensor and 1 analog input, 1 binary input and 1 analog
output. The outputs need to be assigned to the control sequences by parameters. A detailed configuration is possible by
following a simple setup routine. The TCY3 can be configured using the standard operation terminal. No special tool or
software is required.

Vector TCY3-T1102 Series Specifications

General

Model	TCY3-T1102 Series
Category	Controller
Controller Type	Temperature Controller
Input Type	Thermocouple, RTD
Mounting Type	Panel Mount
Weight	Approx. 150 g
Output Type	Relay
Supply Voltage	100 to 240 VAC
Display	Dual Display