Vector VEC1086B User Manual

SMART AUTOMATIC
BATTERY CHARGER
OWNER’S MANUAL & WARRANTY INFORMATION
12 VOLT 2/4/6 AMPERE CHARGE RATES WITH
• IMPORTANT SAFETY INSTRUCTIONS •
WARNING – RISK OF EXPLOSIVE GASES
WARNING - RISK OF EXPLOSIVE GASES
1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
2. To reduce risk of battery explosion, follow these instructions and those published by the battery manufacturer
and manufacturer of any equipment you intend to use in vicinity of battery. Review cautionary markings on
these products and on engine.
GENERAL SAFETY
1. Use this charger for charging a LEAD-ACID battery only. It is not intended to supply power to a low voltage electrical
system other than in a starter-motor application. DO not use this battery charger for dry-cell batteries that are
commonly used with home appliances. These batteries may burst and cause injury to persons and damage to
property.
2. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
3. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
4. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in
a risk of fire and electric shock.
If extension cord must be used, make sure:
a. Pins on plug of extension cord are the same number, size, and shape as those of plug on charger.
b. Extension cord is properly wired and in good electrical condition; and
c. Wire size is AWG#14 (14 gauge) to 100 feet and AWG#12 for distances over 100 feet.
5. Do not operate charger with damaged cord or plug - take to a qualified service technician for replacement of the
cord or plug immediately.
6. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in anyway; take it to
a qualified service technician.
7. Do not disassemble charger; contact a qualified service technician when service or repair is required. Incorrect
reassembly may result in risk of electric shock or fire.
8. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning
off charger controls will not reduce this risk.
9. Do not operate charger in rain or snow or use when wet.
10 .Never charge a frozen battery.
SAVE THESE INSTRUCTIONS:
This manual contains important safety and operating instructions for battery charger Model VEC1086B
4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312 • TEL: 954-584-4446 • FAX: 954-584-5556 • TOLL-FREE 866-584-5504
VEC1086B
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Vector VEC1086B Specifications

General

Type	Automatic Battery Charger
Battery Voltage	6V/12V
Input Voltage	120V AC
Input Frequency	60Hz
Automatic Shutoff	Yes
Reverse Polarity Protection	Yes
Overcharge Protection	Yes
Output Current	8A
Battery Type	Standard, AGM, Gel
Features	LED Indicators
Charging Modes	Automatic

Summary

Important Safety Instructions

Warning - Risk of Explosive Gases

Highlights dangers of explosive gases during normal battery operation and stresses following instructions.

General Safety

Use for Lead-Acid Batteries Only

Ensures charger is used only for lead-acid batteries, not dry-cell types, to prevent damage or injury.

Use Recommended Attachments

Damaged Cord or Plug

Instructs to take charger to a qualified technician if cord or plug is damaged.

Damaged Unit

Advises seeking qualified technician if charger is dropped, struck, or damaged.

No Disassembly

Prohibits user disassembly; requires service from a qualified technician to avoid shock or fire.

Unplug Before Maintenance

Emphasizes unplugging the charger before maintenance or cleaning to reduce electric shock risk.

Avoid Wet Conditions

Prohibits operating the charger in rain, snow, or when wet to prevent electric shock.

No Frozen Batteries

Warns against charging batteries that are frozen, as this can cause damage or explosion.

Personal Precautions and Safety

Aid and Safety Supplies

Ensures someone is nearby and advises keeping soap and water accessible for acid contact.

Eye Protection and Skin Contact

Recommends eye protection and avoiding touching eyes/skin; provides first aid for acid exposure.

Acid Contact with Skin/Clothing

Instructs to wash skin or clothing immediately with soap and water if battery acid contacts them.

No Sparks or Flames

Strictly prohibits smoking or allowing sparks/flames near batteries or engines to prevent explosion.

Metal Objects and Sparks

Warns that dropping metal objects on a battery can cause sparks, short-circuits, and explosions.

Remove Metal Jewelry

Advises removing metal jewelry to prevent sparks, short-circuits, and severe burns from battery current.

Preparing to Charge

Battery Removal and Cleaning

Ensure Ventilation

Stresses the need for good ventilation around the battery during charging to disperse gases.

Initial Charging Rate

Charger Location

Avoid Placing Above Battery

Never place the charger directly above a battery to prevent corrosion from gases.

Prevent Acid Drips

Restricted Areas

Do not operate the charger in a restricted or non-ventilated area.

DC Connection Precautions

Disconnect AC First

Connect and disconnect DC output clamps only after unplugging the AC cord from the outlet.

No Clamp Touching

Never allow the DC output clamps to touch each other to prevent short circuits.

Secure Clamp Connection

Attach clamps securely to battery posts to ensure a good connection and reduce sparking risk.

Battery Installed in Vehicle

Position Cords Safely

Stay Clear of Moving Parts

Check Battery Polarity

Determine Grounded Post

Connect Negative Ground Vehicle

Connect Positive Ground Vehicle

Engine Off During Charging

Battery Installed Outside Vehicle

Check Battery Post Polarity

Connect Positive Clamp

Connect Negative Clamp Safely

Set Charge Rate

Disconnect Sequence

Controls and Indicators

2/4/6 AMP Function

FAULT Indicator

Rev. Polarity Indicator

Charging Complete Indicator

Charge Rate Selection and Charging

Selecting Charge Rate

Charging the Battery

Automatic Float Charging

Troubleshooting

Fault LED Conditions

Explains common causes for the FAULT LED lighting up and their solutions.