Tier 4 Engines
VeeCAN 320
TM
The VEM supports not only lamp informatin
for Tier 4 engines but also has the ability to
send CAN commands for Rorced Regen,
Regen Inhibit, and Auto eliminating the need
for the physical switch on the dash.
VeeCAN 320
TM
To access the T4 Control, go into Configuration
Menu, press Key 1 to scroll to T4 Control, than
press Key 4 to acess.
Key
1: Change the mode to Forced Regen.
Key 2: Change the mode to Auto.
Note. Auto is the default setting.
Key 3: Change the mode to Inhibited.
Key 5: Exit to Configutation Menu.
NOTE: Please refer to engine manual for further information reguarding
actions required for Tier 4 engines.
Forced Regen -
Hold until HEST
Lamp appears
If engine has other
faults, Regen may
not initiate
Find a safe
location, place in
neutral, apply
parking brake
To Next Page
Loading...