Need help?Do you have a question about the Veho CAVE VHS-002-IPC and is the answer not in the manual?
General| Connectivity | Wi-Fi |
|---|---|
| Night Vision | Yes |
| Motion Detection | Yes |
| Two-way Audio | Yes |
| Storage | MicroSD card (up to 128GB) |
| Operating Temperature | -10°C to 50°C |
| Night Vision Range | 10 meters |
Details the three specific sounds ('Sonic Wave', 'Bong', 'Success Tone') the camera makes during pairing.
Connect the camera to power, open the app, and select 'Add Accessory' then 'By scanning QR Code'.
Scan the camera's QR code via the app, then input Wi-Fi details and press 'Start'.
Once the 'Sonic Wave' sound begins, press the 'RESET' button on the camera's rear once.
Observe the green light flashing and listen for the 'Bong' and 'Success Tone' before proceeding.
Name the camera, access 'System Settings', click 'Smart Cameras', and press the '!' icon if offline.
Reset the camera password by pressing 'OK', entering a new one, and confirming for online viewing.
Display all IP cameras connected to the Cave Smart Hub for monitoring.
Capture images, save snapshots, and use the two-way audio feature.
Access and modify the configuration settings for your IP camera.
Configure motion detection to record 18-sec videos with 3-sec pre-recording.
Adjust time zones, flip view, change Wi-Fi, and format SD card for camera operation.
Use the IP camera with generic apps like 'GrapeCam' available for iOS and Android.
Explore compatible accessories such as motion sensors, contact sensors, sirens, and smart bulbs.
Instructions on how to reset the camera by holding the reset button for approximately 5 seconds.
Information on how to get support or troubleshoot issues via the Veho website.
To Next Page