104
105
Owner’s Manual
4.2 History trip data view
Short-press the button SW will enter the history trip data view function, with
TTM and ODO appears first. The user could press the button UP or DOWN
to view the maximum speed, average speed. Short-press the button SW to
exit the data view mode (or it will automatically exit after five minutes riding)
4.3 Method to remove single distance and the single riding time
5 seconds after turning on, under the condition when the meter displays a
single time (TM) and a single distance (DST) environment. Press on the UP
and DOWN key for 3 seconds at the same time, then both of the single time
and single distance are flashing, press on the SW key within 5 seconds to
remove the records of single time and single distance.
5. BATTERY CAPACITY INDICTOR
5.1 Battery capacity indictor
The apparatus could automatically identify the rest battery capacity for the
specified 36 volt or 48 volt battery matching with the controller. When the
rest battery capacity is more than 70%, all the four sections will lighten up,
when the battery capacity decreases, the four sections will extinguish in
turn, when the rest battery is less than 15%, all the four sections will extin-
guish. When the controller closes for the reason of power lack, the LCD
battery indicator will flash to show the battery capacity lack (indicating the
closing condition for the battery capacity lack).
6. USER SETUP
6.1 User setup
User setup items: a. maximum speed; b. wheel diameter selection
(12 - 28inch); c. metric/English unit selection (MPH or Km/H, Mile or Km);
d. With the instruction of professional technician, the user could conduct
the advanced setup to make the motor; controller and apparatus reach the
optimum matching.
3. GENERAL OPERATING
3.1 Open/Shutdown
Press the button SW, then the apparatus enter the normal operating condi-
tion, and the working power is supplied. Under the normal operating condi-
tion, long-press the SW, the power supply will shutdown. When the bicycle
stops, and there is no operation within five successive minutes, the appara-
tus will automatically closed. (Under the closed condition, there is no power
consumption for the apparatus and the controller)
3.2 Change assistant Level
Under normal operating condition, press button UP or DOWN to adjust the
assistant level to change the out coming power. The level scope is 0 and 1
to 5,with the level 1 as the lowest power, the level 5 as the highest power.
Each time the bicycle is turn down, the assistance level will always come to
0 position for satety purpose.
3.3 Back lighting
Long-press the button UP, the back lighting will start (if the controller has
been connected to the front light, the front light will start at the same time),
long-press the button UP again, then the back lighting will close (if the
controller has been connected to the front light, the front light will close at
the same time).
4. TRIP DATA VIEW AND REMOVE
4.1 Trip data under running condition
Under normal condition (non-setup condition), the timing indicator displays
the trip time, mile indicator displays the trip distance, the gear indicator
displays the gear grade, speed indictor displays the speed (Km/H or MPH)
To Next Page
Loading...
Need help?
General
